The light belt is divided into low voltage light belt and conventional light belt. Where is the light belt generally used? The application of indirect light source with floodlit ceiling, supplementary light source under cabinet, supplementary light source in cabinet and decorative light source, should low voltage light belt or high-pressure light belt be applied in these places? Today, the low voltage light manufacturer will introduce the characteristics of these two light belts for everyone to choose from.
No matter the low voltage light belt or the high-voltage light belt, the converter or transformer is used to provide power for the light belt. The difference is that one output voltage is 220v, the other is below 36v, that is, below safe voltage. In terms of appearance, the low voltage light belt needs to change from high pressure to low voltage, so its volume is relatively large, while the high-pressure light belt should be called "voltage stabilizing joint" with relatively small volume, generally smaller than mahjong tiles except for plugs and joints.
In addition to the difference between the conversion joints, the back sheet of the low voltage light belt is generally thin, has no stretchability, and the overall length is limited, generally 5 meters, while the length of the high-pressure light belt is longer, and the maximum length of a bundle is 100 meters. Therefore, if the decorative surface is relatively long, high-voltage light belts should be preferred, such as floodlit ceiling, which is more than 20 meters in a circle, and a lot of heels should be lost with low voltage light belts, and each one should be equipped with a transformer. Of course, the back plate is generally thicker for 10 meters and 20 meters.
No matter the low voltage light band or the high-pressure light band, there is a cutting point, that is, after cutting from the cutting point, add a transformer or a high-voltage connector, and you can get a single light band. The cutting point of the low voltage light band is generally 5-10cm, while the high-pressure light band is generally 1 meter, so the low voltage light band is generally flexible to use.
So under what circumstances do you choose high-voltage light bands and under what circumstances do you use low voltage light bands? What should you pay attention to when using? Use low voltage light belt as far as possible in wading places, such as the supplementary light source under the kitchen cabinet and the supplementary light source of the sink mirror. If there is no place behind or around the mirror where the low voltage light belt transformer is hidden, use high-pressure light belt to place the joint on the upper part of the mirror to avoid splashing water as much as possible. Many cabinets have relatively dark internal light. Some friends choose to supplement lighting with light belts. For safety, they can choose low voltage light belts. However, the transformer should not be placed inside the wardrobe, and a separate switch should be set up to avoid the danger of fire.
What are the other applications of light belts? I think the biggest purpose of the light belt is to supplement the light source and decoration, except for the supplementary lighting of the sink, table top and dressing table just mentioned.
The solar motion sensor light is also one of our product, welcome to buy and purchase!
